Укладка греющего кабеля в слой плиточного клея.
Experts of our company will help you to choose an electric heating system that meets your requirements for power and heat supply. company. а наша монтажная группа произведёт правильную укладку, according to the instructions for installing the heating element.
Before laying the cable, a wiring plan must be drawn up., where the heated areas will be marked, cold wires, as well as the location of the temperature sensor and thermostat. Eliminate all stationary obstacles - bath, sink, built-in wardrobes, etc., since it is impractical to heat the floor under them. The assembly plan is kept together with this manual..
Install thermal insulation on the rough concrete floor (foam, cork-foil, hard foam). If there is a warm room under you, then it is allowed not to lay it, but in any case, the best solution is to insulate the warm slab from the concrete base, as it increases the efficiency of the system.
Make the final concrete screed, to hide the thermal insulation and prepare the base for laying the cable, wait until it dries.
According to your cable layout plan, lay the mounting tape and fix it on the prepared base, with distance between stripes 50-80 cm. Also, instead of mounting tape, you can use a mesh with a cell about 2 cm, the cable is attached to it with a wire, also the mesh serves as a reinforcing belt (mandatory use for wooden floors).
Lay and secure the cable according to the step, selected by you according to the table. Bring the cold ends to that place, where the thermostat will be installed. Cold ends can be lengthened or shortened as required, but do not damage the heating cable. The boundary between cold and hot cable is the sleeve.
HEATING CABLE OVERLAPPING. DURING INSTALLATION PROTECT THE CABLE FROM MECHANICAL DAMAGE. MAIN REQUIREMENT IS CABLE LAYING, NOT DAMAGING IT. AFTER INSTALLING THE CABLE, MEASURE THE RESISTANCE OF THE HEATING ELEMENT AND THE INSULATION, WITH OBLIGATORY REGISTRATION IN THE WARRANTY CARD. COMPARE WITH MANUFACTURER DATA.
Provide a groove in the floor for the temperature sensor tube. The tube is fixed in the groove between the ends of the cable with one bend from the floor to the wall. The tube opening should be closed, to prevent the solution from getting inside.
Connect network leads, cold ends of the system, temperature sensor leads to that place, where the thermostat will be installed. Make a test connection (according to the instructions for connecting the thermostat). Feel the cable with your hand, if it starts to heat up, then disconnect everything, and proceed to the next step.
Apply a layer of tile adhesive, about 5-6 mm, notched trowel on the heating element. After that, lay the tiles..
! THE FIRST TIME OF THE HEATING ELEMENT IS NOT PRIOR TO, THAN THROUGH 48 HOURS AFTER INSTALLATION! IN THE CASE OF THE FORMATION OF A CONCRETE SCREED, THE SWITCH-ON IS PRODUCED THROUGH 25-30 DAYS!
